Relocating device
Hi, I am working on a project using imp 001 as a capacitive change sensor and (thanks to some advice from Hugo) all is going well.However, I need to send the prototype to another location for practical...
View ArticlePulse Sensor Amped Heart Rate Monitor
I am looking to use the PulseSensor Amped heart rate monitor for a project (pulsesensor.com). Arduino code is available, but I haven't found anything for the electric imp. Does anyone know if there is...
View Articlehow much data can the imp agent hold to pass on to a device.
A hypothetical scenario. If i have an imp running a small piece of code with a delay in it, say, turn on a pin high, wait for 10 seconds, then turn pin off and sit idle. The action is initiated from...
View Articleimp Store Updates
Hi everyone,Thank you for your interest in the imp Store (store.electricimp.com). We had a great initial launch in the U.S. last month. We know that there is interest in different parts of the world,...
View ArticleimpOS 36's Fast Start for hobbyists?
I have some imp001 projects where impOS 36's Fast Start functionality would be very useful, as I'm currently integrating a small LiPo charge+backup addition to the device to keep the imp powered while...
View Articlebudweiser red light
looking at past post, i too need help connecting my budweiser red light to wifi. it worked last season but over the summer we upgraded our router and now red light wont connect
View ArticleBudweiser Red Light
Just got a budweiser red light and all going well until trying to get the wifi to connect. Help has not worked. Wifi chip goes red-yellow blinking then blinks greens for a few minutes then turns...
View ArticleHX711, WeightSensor, LoadCell (old Title: Reading a 7-Segment Display with...
Hi Folks,did anyone tried to read a 7-Segment Display with the eImp?What IC did you use to connect all the input pins?Chrischi
View Article